Category Archives: Working At Heights

Working At Heights

Everyone is responsible for preventing falls when working at heights.  The building owner/property manager/owner’s representative, the self-employed contractor, any subcontractor and the worker are all responsible for safety considerations when on a roof.

The concern for health and safety on a roof becomes critical as soon as someone steps foot on a roof (and not just when they “get close” to the edge).  All aspects of working safely at heights should be considered.  The general rule is that fall protection is required: 

  • In Canada, where any section of the parapet wall is less than 36 inches (and someone is subject to a 10 foot fall)
  • In the USA, where any section of the parapet wall is less than 42 inches (and someone is subject to a 4 foot fall)

Preventing falls from heights is a priority for the Department of Labour (DOL) and Ministry of Labour (MOL).  Each expects contractors and employers with staff working at heights to actively manage any significant hazard.

Controlling the Hazard 

In order to stay safe when working at heights you must ensure effective controls are in place to prevent people from being harmed.

To select the most effective controls, you must consider the following steps: 

  • Eliminate the chances of a fall by doing as much of the preparation work as possible before work begins.  Normally this is done by doing a fall hazard roof assessment.  The assessment report will review all aspects of safe access and egress for all work activities that may take place on the roof.  The intent is to isolate the worker from the risk of a fall by using guard rails, scaffolds and roof edge protection as means of prevention.  In some situations a combination of controls will be required to ensure safe work.
  • Edge protection is imperative.  Edge protection should be used as a means of isolating workers from a fall.  This includes guard rails, horizontal life lines, localized tieback and lifeline anchors, access ladders and catwalks.  Edge protection should be provided on all the exposed edges of a roof, including the perimeter of buildings, skylights or other fragile roof materials and for any openings in the roof.  This also applies to openings and edges of floor areas.
  • Where there is the risk of workers falling through openings in a roof, the openings should be identified and guarded. 

SWEETS1

Check List for Working Safely on a Roof 

  • Are workers trained or supervised to work on a roof, near the roof edge or over the edge using suspended equipment safely?
  • Has a full hazard assessment been completed before work starts?
  • Is there safe access to all roof areas?
  • Has the contractor provided a work plan to safely access the building edge or facade?
  • Have the roof and fall arrest system been inspected, reviewed and tested if needed?
  • Have all the access restrictions been identified and understood by the contractors?
  • Are workers protected from falling off roof edges and do they have a rescue plan?
  • Are workers protected from falling from incomplete roofs?
  • Are workers protected from falling through skylights and penetrations or other brittle roofing?
  • Are people below the work protected from the dangers of falling materials?
  • Do roof workers have appropriate footwear to prevent them from slipping?
  • Are the weather conditions suitable for working on a roof?
  • Have lower electrical hazards and vehicle traffic hazards been identified?  

Other Possible Considerations

  • Eliminate the hazard of a fall from a roof.
  • Work from the ground.
  • Work from inside where there is no possibility of a fall.
  • Prefabricate components at ground level or prior to installation.
  • Remove complete fixtures to ground level or shop for maintenance (e.g. air conditioning units).
  • Pre-paint fixtures/roof prior to installation.
  • When isolating the hazard of a fall from a roof you can consider some addition temporary protections.
  • Scaffolding and mobile scaffolds/step platforms/working in an elevating work platform.

It is the law so doing nothing to address safety when working at heights is not an option!

worker